The Genie CT10 is a coaxial and UTP cable tester and is a “must have” accessory for the professional installer. Operating for up to 3 hours continuously from fully charged (6 hours for coaxial), this extremely useful device will detect faults up to 200m on UTP cable and up to 1.8km (RG-6) for coaxial. The CT10 is very simple to operate with a clear 1.5” high definition display. 

Features:

• Coax / UTP cable tester, cable length and mapping, open, short status check
• Measuring Coax cable up to 1.8km, UTP cable up to 200m, measure UTP cable up to 600m with BNC to RJ45 connector (1p)
• 1.5” high definition OLED display
• Cable loop resistance measurement function
• Calibration function : add the measurements of your own cable data, maximum storable cable data : Coax: 8, UTP: 8
• Built-in rechargeable battery for up to 3 hours in continuous use
• Built-in basic cable data, various cable data built-in (Coax: 8 types, UTP: 4 types)

Specifications:

• Display - 1.5” OLED
• Cable Test Type - BNC Coaxial / RJ45 UTP (T568A, 568B)
• Maximum Length - Coax Cable - 10m ~ 1.8km (RG-6)
• Maximum Length – UTP Cable - 5m ~ 200m (UTP) / 150m (STP)
• Minimum Calibration Length - Over 100m recommended
• Error Rate (BNC, RJ45) - ±5% (After Calibration)
• Compatible Connector Type - BNC, RJ45
• Coaxial Cable Loop Resistance - 300Ω (Max)
• Cable Map Display - OLED (#1 – #8)
• Battery Type - 3.7V Rechargeable lithium battery 900mAh
• Recharge Port - USB 2.0 Mini-B Type, Over DC5V 600mA (USB charger)
• Full Charge Time / Continuous Use Time - 2h 30m / RJ45 (3h), BNC (6h)
• Temperature - -10°C ~ +50°C
• Humidity - 0 ~ 80%
• Case - ABS UL94V-0
• Dimensions - 120 x 74 x 33 mm
• Weight - 210g